winIDEA with XCP
XCP can be used with winIDEA as a:
- winIDEA XCP Slave Plugin or
- winIDEA XCP Master.
winIDEA XCP Slave Plugin
Master applications (e.g., Vector CANoe, CANape) can communicate via an XCP protocol with winIDEA and/or BlueBox. All supported microcontrollers can be handled by the XCP plugin.
Features are:
- Synchronous data acquisition (DAQ)
- Direct memory access (Polling)
- Online memory calibration (read/write access)
- Time-stamped data transfer, generation of event timestamps by the ECU/Emulator
- Trace-to-XCP bridge
- A2L File Generation
winIDEA XCP Master
winIDEA communicates via XCP protocol with Plug-on Device (POD) by the measurement/calibration (MC) tool vendor (or from any provider that implements an XCP Slave according to the standard). The POD connects via a debug interface (e.g., DAP, JTAG) to the target ECU. The communication between the host computer and POD is performed via XCP over Ethernet. Almost all winIDEA features are provided in a similar winIDEA configuration (debug, flash, on-chip trace, etc.). Supported microcontrollers are Infineon AURIX TC2xx, TC3xx, and Power Architecture MPC5xxx.
