car engine
Find results that contain at least one of the two words.
"car engine"
Find results that contain the exact phrase 'car engine'.
+car +engine
Find results that contain both words.
car -engine
Find results that contain the word 'car' but not 'engine'.
car*
Partial match. Find results like 'car', 'carneval', 'carousell'.
Infineon TriCore: DAP/DAPE configuration issues
29-Nov-2024
Possible issues and solutions
DAP/DAPE connector misconfiguration
In case the target has a DAP/DAPE connector
without a notch (keying shroud), make sure you properly orient the
connector. Pin 1 from the Active Probe must align with the pin 1 from the
target.
Make sure that signals on the target connector are not mirrored. Check
the
Hardware User Manual to see which signals are assigned to each pin.
DAP/DAPE cable misconfiguration
Make sure:
DAP cable (Active Probe) is connected to DAP connector (Target)
(optional) DAPE cable (Active Probe) is connected to DAPE connector
(Target)
DAP/DAPE winIDEA misconfiguration
Refer to Infineon’s documentation and check which Debug Mode (Standard,
Wide) is supported on your target.
Make sure to select the supported Debug channel Mode (DAP Wide / Standard) via Hardware | CPU Options | SoC.
DAP and DAPE on TC4x devices share one pin, thus DAP Wide cannot be used on
both at the same time.