🎉 We're happy to announce new public releases! ðŸŽ‰

  • SWAT v1.1r1 - Software tracing solution now supporting more architectures and operating systems - see SWAT Release Notes.
  • TriCore v6.2r2 Inspector v1.0r8 - An automated method for identifying toolset issues in compiled output code.
  • VX-toolset for Arm - v8.0r1 - A certified compiler toolset for safety-critical embedded software development on Arm cores.
Contact us to get access!

car engine
Find results that contain at least one of the two words.

"car engine"
Find results that contain the exact phrase 'car engine'.

+car +engine
Find results that contain both words.

car -engine
Find results that contain the word 'car' but not 'engine'.

car*
Partial match. Find results like 'car', 'carneval', 'carousell'.

Connect iC7max/iC5700 BlueBox and Target via Active Probe

24-Sep-2024

The Active Probe is connected to the target on one side and the other side it connects to the iC7max/iC5700 FNet port via the FNet cable.

In the Setup and Configure Hardware Tutorial you'll find detailed steps to connect to the following Active Probes:

  • Infineon DAP/DAPE II
  • AGBT/SGBT/Aurora Active Probe (Infineon AGBT, Infineon SGBT (HSTCU), Arm HSSTP II, RH850 Aurora, MPC5x/SPC5X Aurora)
  • Active Probe Debug
  • Active Probe Parallel


More resources

Was this answer helpful?
Same category topics
See category...
Similar topics