Categories

{{ selectedCategory.name }}

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!

Power measurement with Power Probe and ADIO add-on module

03-Jul-2024

Solution

After you have successfully connected hardware and selected the current range according to the shunt resistor (JB1 jumper block), and voltage range depending on your target power supply range (JB2 jumper block ) on the Power Probe, configure the following settings in winIDEA


More resources


Was this answer helpful?

Sorry this article didn't answer your question, we'd love to hear how we can improve it.
Note: This form won't submit a case. We'll just use it to make this article better.

Similar topics

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No similar topics found!

Other topics in the same category

{{ topic.Title }} {{ topic.Ddate | formatDate }}

{{ topic.Content }}

No topics found!